Mostrando postagens com marcador network. Mostrar todas as postagens
Mostrando postagens com marcador network. Mostrar todas as postagens

sexta-feira, fevereiro 06, 2009

Vyatta (Openswan) versus SonicWALL IPSec

After some hair pulling, I found out how to set up a Vyatta <-> SonicWALL IPSec site-to-site tunnel.

Vyatta 4.1.4 uses Openswan 2.4.2, which can interoperate with SonicWALL. turns out it needs some specific configurations though, and some of those options were not available on the configuration setup.
Thankfully, being linux I could just vim/etc/ipsec.conf and tweak the Openswan settings.


#ipsec.conf
#these are the options which should be in your tunnel:
esp=3des-md5 # instead of esp=3des-md5-modp1024
pfs=yes # this is changeable by the configuration commands I believe
keyexchange=ike #didnt exist

quarta-feira, fevereiro 04, 2009

Vyatta, network setup.

VICTORY! or almost...

I managed to set up the internet, NAT, firewall, poke the holes I needed. Now all that's there to it is the VPN tunnel.

I have also set up a separate machine running Dnsmasq as a DNS cache/DHCP server, and a HTTP(S) reverse proxy. Which is nice, because I have a single fixed IP and I want different machines to serve separate subdomains. like using Zimbra to serve webmail.mydomain.com, my database web interface from db.mydomain.com, and the plain websites from www.mydomain.com.

Word of advice: use the Apache Header module to make sure you are telling the browser to NOT cache your pages. at least while you are setting it up. Would have saved me a few headaches if I had done it prior to trying to set up the reverse proxy.

quinta-feira, janeiro 29, 2009

Rename VMWare Server 2.0 bridges

After my brilliant eth* renaming merry-go-round, I had another simple, but annoyingly hard-to-find-info about mission: change bridge names (just the labels) in VMWare.

After hastily running through the settings wizard on running vmware-config.pl, I realized that I had 4 bridges:
Bridge
Bridge(2)
Bridge(3)
Bridge(4)

Which are not very helpful names. Sure, I could have given the right names from the start, but I am just human. Everyone looks back and say ' I could hve done that one better' right?
After NOT finding any info on how to do it, I just tried the shotgun approach and got to dig on the vmware-config.pl command options.

Turns out I am a lucky guy. When i got to the network reconfiguration section, I told I wanted to change network settings, but instead of using the wizard ( as I always do - many people might do it too) I used the editor option. there we can change the network setting of all configured bridges, NATs and host-only networks. So I renamed all my bridges to "Bridge eth*" and it was all set.